by admin | Jul 23, 2019 | Rebuild, VW Rebuild
by admin | Jul 17, 2019 | Rebuild, VW Rebuild
Push rod tubes. Always use new tubes and new seals. For longevity via oil cooling use STOCK style. Paint flat black for cooking. Install with seams up.
by admin | Jul 17, 2019 | Rebuild, VW Rebuild
Initial cleaning Examine the case to determine if serviceable. You are looking for stripped, broken, or missing bolts and studs, cracks in the case. Knowing the overall condition of your case is necessary so that you can make the correct choices to proceed. Stripped...
by admin | Jul 17, 2019 | Rebuild, VW Rebuild
Bearings Case nuts After Receiving: Measure Bearings and make sure they are the correct size. They might have been mis-boxed.Measure dowel pins , specifically for length against your dowel pin holes. Too long and the bearing will pinch and be too tight against the...
by admin | Jul 17, 2019 | Rebuild, VW Rebuild
Install dowel pins. Test fit the main thrust bearings. Mark the centerline of the bearing to make installation with crank easier. Fit the bearings to the crank. Put a light film of oil on the bearing surfaces to avoid any inadvertent scratching. They should go on with...
by admin | Jul 17, 2019 | Rebuild, VW Rebuild
Evaluate what you have: Check compression. Make notes on all, as it will help identification of any problems after you open up the engine.What is know about the engine. Rod knocking? Piston blown through case? Rocker arm fell off? Tools Must have: Manual. Haynes at...
by admin | Jul 17, 2019 | Rebuild, VW Rebuild
When disassembling the rods, do one at a time, and reassemble the caps and bolts in the same position as taken off. The purpose is to keep the rod together with it’s matching and possibly already balanced parts.
Recent Comments